Chevrolet 4.3L 1986-1992 262 V6 Block # 10105867Click here to purchase or contact the seller of this item on eBay |
![]() |
|
Current Price: 285.00 USD |
Chevrolet 4.3 Roller Cam V6 Bare Block Core GM / Chevrolet Engine
Ready for remanufacturing.
- Block has been baked
- blasted
- magnafluxed
- drilled for mechanical fuel pump.
- Casting # 10105867
Cylinder bores, main saddles and lifter galley have been inspected. Ready for remanufacturing. Block may need to be line honed.
Replaces block casting numbers: 10105867, 10172756, 14099073, 14093683 and 10066011
MerCruiser part number: 14149R5 841-9956, 841-9690
175 (2 BBL.) GM 262 V-6 1987
205 (4 BBL.) GM 262 V-6 1987
4.3L (2 BBL.) GM 262 V-6 1988-1992
4.3LX (4 BBL.) GM 262 V-6 1988-1992
4.3L GM 262 V-6 1988-1994
TECH NOTES
1987- ’94 WITHOUT BALANCE SHAFT: In 1987, a roller lifter cam was installed, so
the block was changed again. Two bolt bosses were added in the middle of the
valley for the lifter retainer that kept the rollers properly located on the
cam and perpendicular to it. This same basic block was used through ’91 for
everything, and in ’92 through ’94 for all of the engines without balance
shafts except for one small difference – some of the blocks came with four bolt
holes for the tunnel style retainer beginning in ’92. There were several
different castings used, including the 10105867, 10172756, 14099073, 14093683
and 10066011 with the two-bolt retainer, and the 10172756, 14099073 and
10066061 blocks with the four-bolt retainer. LIFTER RETAINERS..The
roller cam motors have used three different lifter retainers. All of the ’87
through ’91 non-balancer blocks and some of the ’92s used a flat retainer (p/n
10046165) with two bolt holes in the middle. As of ’92, all of the balancer
motors and some of the non-balancer motors came with the tunnel-shaped retainer
(p/n 10105916) with four bolt holes, two on the outer edge on each side. Starting
in ’94, Chevy used two plastic retainers (p/n 12551431) that are bolt-in
replacements for the tunnel-shaped version. There are some later intakes that
will hit on the reinforcing ribs on the tunnel-shaped retainer, so it’s best to
use the plastic retainers in all of the blocks that have the four bolt holes.
Shipping rate applies to continental
United States only.
Alaska, Hawaii, Guam,
Puerto Rico & Virgin Islands, please email me for shipping rates.
**********************
|
|
|
|
|
|
|
Click here to purchase or contact the seller of this item on eBay